Replacement frame for BetaFPV Meteor75 / Pro / Pro 2 (black)

Fits the BetaFPV Meteor75, Meteor75 Pro and Meteor75 Pro 2. Simply move the parts of your Meteor over to this frame.

Handmade, not mass-produced. We print every frame individually ourselves from PA12-CF, a very strong carbon-fibre nylon, heat-treat it in the oven and finish it by hand.

Bigger battery bay

The frame takes a 1S battery with 1100 mAh – almost double the stock batteries of the Meteor75. You will not fly twice as long, because the bigger pack is also heavier, but noticeably longer.

The battery is held by a clip. To swap, push it back a little and the battery slides out. In flight it sits firmly – no hook-and-loop strap stretching out over time.

Battery we use / recommend: GNB 1100 mAh 1S 60C HV.

Propeller guards

The frame has regular, open propeller guards. They take light contact with walls and furniture – handy when you fly indoors.

Heat-treated

After printing, every frame goes into the oven. This makes it harder and stiffer, and it keeps its shape better. The guards barely bend on impact, so the props take less of a hit.

The frame takes a lot of punishment. If something does break in a really hard crash, it is more likely the frame than the props.

Specifications

• Fits: BetaFPV Meteor75, Meteor75 Pro, Meteor75 Pro 2
• Propellers: 45 mm
• Outer dimensions: 111.7 × 107.7 × 17.8 mm
• Weight: approx. 12 g
• Battery bay: 27 × 57.5 × 8 mm, for 1S 1100 mAh packs
• Battery retention: clip
• Propeller protection: open guards
• Material: PA12-CF
• Colour: black

What you get

• 1 × frame (black, heat-treated)
• 5 × battery clip – spares in case one breaks. You can add more above (0.50 € each).

Not included: electronics, propellers, battery and motor screws. The photos show a fully assembled drone.

Please note: you get the finished printed frame, not a print file.